User Manual

REV2 Auto‐Ohm200S3/DMOM‐200S3/DMOM‐600USER’SMANUAL
41 
3.5.3. Restoring a Test Record From Flash EEPROM
UsethestepsbelowtorestoreatestrecordfromtheAuto‐Ohm’sinternalFlashEEPROMtothe
workingmemory:
a. Startfromthe“START‐UP”menu:

Pressthe[2]key(SETUP).
b. Thefollowingscreenwillbedisplayed:

Pressthe[3]key(SAVE/RESTORERECORD).
c. Thefollowingscreenwillbedisplayed:


NOTE
Option5(COPYTOTHUMBDRIVE)willbelistedonlyifaUSBFlashdriveis
connectedtotheunit.
Pressthe[1]key(RESTORERECORD).
1. RESTORE RECORD
2. SAVE RECORD
3. RECORD DIRECTORY
4. ERASE RECORD
5. COPY to THUMB DRIVE
1. RECORD ID
2. REVIEW RECORD
3. SAVE/RESTORE RECORD
4. SET TIME
5. SET LANGUAGE
1.RUN TEST
2.SETUP
3.QUICK TEST
time: 14:21:34
date: 05/24/11