Owner`s manual

www.desatech.com
105604-01K12
INSTALLING LOG HEATER IN
FIREBOX
CAUTION: Do not remove the






   

1. Remove four screws holding rebox bottom
in place.
2. Lift and remove rebox bottom (see Figure 13).
3. If installing GA3750A blower accessory
(Models FB32CA and NLFB32C only), see
Installing Blower Accessory, page 10.
4. Route exible gas line from manual shutoff
valve into rebox through side.
   
    

is recommended to allow ac-

-
tion to the manual shutoff valve

5. Install and properly test gas log heater. Follow
installation instructions included with the vent-
free gas log heater that is being installed.
6. Replace firebox bottom and secure with
screws.
INSTALLATION
Continued
Figure 13 - Removing Firebox Bottom
Screws
INSTALLING FIREPLACE HOOD
   
     



1. Attach three zinc-colored shoulder screws to
back of hood.
2. Insert hood into hood-mounting slots on
rebox.
3. Hold hood in place. Insert two black Phillips
screws through bottom of hood and tighten.
Figure 14 - Installing Fireplace Hood
Hood
Hood
Mounting
Slot
Screw
Shoulder
Screw
INSTALLING FIREPLACE SCREEN
1. Insert each rod through nine rings located at
top of screen.
2. Insert rst rod into rear hole in left side of
rebox. Fasten rod to rear hole near center of
rebox using black shoulder screw.
3. Insert other rod into front hole on right side of
rebox and fasten using remaining shoulder
screw.
Figure 15 - Installing Fireplace Screen
(Shown Without Fireplace Hood for
Clarity)
Rod
Front and
Rear Hole
Ring
Screen
Screw