User Manual

REV 1 TRM-203 AND TRM-403 USER’S MANUAL

Press the [1] key (COPPER, Tk=234.5) to select copper as the winding material.

Continue to step k.

Press the [2] key (ALUMINUM, Tk=225.0) to select aluminum as the winding

material. Continue to step k.

Press the [3] key (MANUALLY ENTER Tk) to manually enter the Tk value. The

following screen will be displayed:

You can increase the Tk value by 0.5°C increments by pressing the [∧] key.

You can decrease the Tk value by 0.5°C increments by pressing the [∨] key.

Press the [ENTER] key to confirm the temperature setting. Continue to step k.

2. NO

Press the

[2] key (NO) if you do NOT wish to convert readings to standard

temperature. Continue to step m.

k. The following screen will be displayed:

Use the

[∧] and [∨] keys to adjust the D.U.T. (Device Under Test) temperature.

D.U.T. TEMP:

25.0

°C 77.0°F

↑↓ to adjust tk

"ENTER" to accept

TK:

230.0

°C

↑↓ to adjust tk

"ENTER" to accept

WINDING MATERIAL:

1. COPPER, TK=234.5

2. ALUMINUM, TK=225.0

3. MANUALLY ENTER TK