User Manual

TRM-203 AND TRM-403 USER’S MANUAL REV 1

After the TRM has finished its internal calibration, the following screen will be displayed:

When the TRM has determined that the resistance reading is stable, the following

screen will be displayed:

Press the [ENTER] key or the LTC [RAISE] or [LOWER] key to continue.

h. The following screen will be displayed:

Press the

[1] key (LATCHED).

i. The TRM will start capturing data and the following screen will be displayed:

The second line on the screen will display the remaining time for the test. While the

TRM captures data, you can press the LTC

[RAISE] or [LOWER] button to cycle

through the LTC or Voltage Regulator’s taps. You can wait for the remainder of the test

time or you can press the [STOP] key at any time to end the test. If you have

RUNNING DYNAMIC

LTC TEST T=239

"STOP" TO END TEST

** XFMR ENERGIZED! **

TAP SWITCH OPERATION:

1. LATCHED

2. MOMENTARY

PRESS "ENTER" 00:01

OR LTC RAISE/LOWER

TO START TIMING...

I = 9.98 AMPS

*XFMR CHARGING*

please wait...

I = 1.90 AMPS

** XFMR ENERGIZED! **