Owner's manual

REV 2 WRM-10 USER’S MANUAL

3.3 Performing Transformer Tests

3.3.1. Performing a Single Resistance Test

a. Start from the “MAIN MENU”:

Press the [CONTROL KNOB].

b. The following screen will be displayed:

Turn the [CONTROL KNOB] till the following screen is displayed:

Press the [CONTROL KNOB].

c. The following screen will be displayed:

Press the [CONTROL KNOB].

d. The following screen will be displayed:

Press the

[CONTROL KNOB] to start the test. You can abort the test by turning the

[CONTROL KNOB].

e. The following screen will be displayed:

The above screen will continue to display while the WRM-10 is performing the test (the

lightning bolts will be flashing). When the WRM-10 has determined that the resistance

readings are stable, the test results will be displayed as shown:

R1 = 10.0 mΩ

R2 = 10.5 mΩ

*XFMR CHARGING

“PRESS” TO START

“TURN” TO ABORT

FLASH-OVER IF

CABLES REMOVED!

RUN TEST

RUN TEST

MAIN MENU