Manual

WRM-10P AND WRM-40 USER’S MANUAL REV 3

e. The following screen will be displayed:

If the tap information is correct, press the [1] key (YES) and continue to step f.

If the tap information is incorrect, press the [2] key (NO) and return to step d.

f. The following screen will be displayed:

1. YES

Press the [1] key (YES) if you wish to convert readings to standard temperature.

The following screen will be displayed:

Press the [1] key (COPPER, Tk=234.5) to select copper as the winding material.

Continue to step g.

Press the [2] key (ALUMINUM, Tk=225) to select aluminum as the winding

material. Continue to step g.

Press the [3] key (MANUALLY ENTER Tk) to manually enter the Tk value. The

following screen will be displayed:

You can increase the Tk value by 0.5°C increments by pressing the

[PAPER ∧

Contrast]

key.

You can decrease the Tk value by 0.5°C increments by pressing the

[PAPER ∨

Contrast]

key.

Press the [ENTER] key to confirm the temperature setting. Continue to step g.

2. NO

Press the [2] key (NO) if you do NOT wish to convert readings to standard

temperature. Continue to step g.

Tk:

230.0°C

↑↓ to adjust Tk

“ENTER” to accept

WINDING MATERIAL:

4. COPPER, Tk=234.5

5. ALUMINUM, Tk=225

6. MANUALLY ENTER Tk

CONVERT READINGS

TO STANDARD TEMP?

1. YES

2. NO

3 LOWER,N,3 RAISE

IS THIS CORRECT?

1. YES

2. NO