Installation Guide

Customer Service: 833-9VANITY
www.
vanityart
.com
Customer Service: 833-9VANITY
www.
vanityart
.com
1. Installation for Overflow Cover and Drain
2. LEAK TEST BEFORE FINAL INSTALLATION
NOTE:
If overflow and drain were pre-installed to the tub, then skip this section and go to section
1. Locate hardware package. Remove overflow.
Ensure the area on the bathtub is clean, dry, and
free from any debris. Apply a bead of silicone
sealant around the back of the insert, (being
careful to not apply too much).
6. Apply a fresh bead of clear silicone around
the lower rubber gasket (D) then pass it over the
bottom of the drain body (B) until it's touching
2-leak test before final installation on page 5.(If don't have overflow, please skip this step)
the bottom of the bathtub.
4. Remove the drain assembly and disassembly
parts A-E then proceed to step 5.
Drain Plug
Silicone
Bathtub
Bathtub
Overflow Hardware
Bathtub
Ppo-Up Drain Body
Upper Rubber Gasket
Lower Rubber Gasket
Drain Body Nut
A
A
A
C
C
B
B
B
C
D
E
3. Hold in place and confirm that the overflow
is inserted flat and that it appears level from all
viewable angles. Then apply tape to keep it in
place until cured. After 24 hours the tape can be
removed.
2. Press the overflow insert into the opening
firmly. Be sure to wipe away any excess sealant
that may come out.
7. Attach the drain body nut (E) to the bottom
of the drain body (B). Use an adjustable Wrench
to tighten until the drain body nut (E), and lower
rubber gasket (D) create a seal with the bottom
of the bathtub.
CAUTION: DO NOT OVERTIGHTEN
Over tightening could break the seal or crack the
bathtub.
5. Pass the upper rubber gasket (C) over the
bottom of the drain body up to the drain flange
until they're flush. Apply silicone both above
and below the upper rubber gasket (C) and pass
both pieces through the drain hole.
D
D
C
C
D
E
B
B
A
A
- Set your bathtub on two 4x4 lumber pieces so you
can have access from the bottom of the bathtub.
Put a tray beneath the bathtub.
- VERY IMPORTANT! Before processing with
installation, please check that the push pop-up,
drain, and integrated overflow are properly sealed
and tightened.
- Push the pop-up into a close position and fill the
bathtub with cold water above the overflow level to
test for overflow leakage and drain leakage.
- Check for any leaks around the drain and pipe.
(NOTE: Due to surface tension, it is normal for a
small amount of water to pool around the drain.)
- If a leakage occurs please disassemble the drain
line or overflow assemblies and you can apply a
plumbing silicone caulk to fix the leakage.
- Once the leakage test is performed you may
proceed to the installation.
IMPORTANT:
Please select the correct type of installation with your new tub. This manual includes installation
with underfloor access (page 6) and installation on the slab floor (no underfloor access) on
page 9.
If your tub came with a Down Force Drain Kit (in a separate box), please follow the installation
guide included with the drain throughout your installation.
3PAGE 4PAGE