Installation Guide

Drain Plug
Ppo-Up Drain Body
Upper Rubber Gasket
Lower Rubber Gasket
Drain Body Nut
Tailpiece
(provided by installer)
Trap Adapter
Drain Pipe
(provided by installer)
Trap
(provided by installer)
Floor
SOFT BLANKET
TOP
Level
Tub Feet Leveler
Tub
Wall
1/8"
Customer Service: 833-9VANITY
www.
vanityart
.com
Customer Service: 833-9VANITY
www.
vanityart
.com
3. INSTALLATION WITH UNDERFLOOR ACCESS
1. Clean, level and prepare the floor for installation. Place the tub in the exact installed location on
the floor trace the outline of the bathtub with a pencil and mark the drain hole location on the floor.
Move the tub away so that the plumbing can be installed.
6. Try to put the tub in the desired position. Once the tub position is certain, apply a bead of
waterproof silicone (or other suitable adhesive) to the bottom of the tub.
5. Measure and cut the tailpiece to the
appropriate length to reach the trap adapter
when setting the tub drain, insert the
tailpiece with a 1-1/2" slip joint and rubber
washer into the trap adapter, and tighten
properly.
2. Turn the bathtub upside down and set it on a non-abrasive mat, blanket, or cardboard to prevent
any scratches on the tub rim.
7. Flip the tub over and carefully set the tub into position with tailpiece assembly to P-trap and
connect to the drain.
3. Place a level across the bottom of the tub and adjust the tub feet leveler to touch the level. Then
raise the leveler an additional 1/8" or 3/16" so that the weight of the tub, water, and user are fully
supported by the feet adjuster and not the tub walls.
4. Install a 1-1/2" tailpiece along with the corresponding flanged washer and 1-1/2" nut to the drain
body.
5PAGE 6PAGE