Installation Guide

Customer Service: 833-9VANITY
www.
vanityart
.com
Customer Service: 833-9VANITY
www.
vanityart
.com
8. Flip the tub over and carefully set the tub into position with piece assembly to the waste vent and
connect it to the drain.
6. Install a 1-1/2" rubber slip gasket over the drain waste vent.
10. DO NOT SHOWER or MOVE the tub after installation because it will take about 24 hours to get
the silicone to dry.
7. Apply a generous bead of adhesive or waterproof silicone to the bottom of the tub and caulk
around the edge of the tub.
5. Clean the surrounding of the drain pipe with cloth in preparation for setting the drain, the area
should be dry and free of any debris. Apply a bead of clean silicone or plumber putty around the
drain body and pass it through the drain hole, also apply plumber putty to the washer and slide it
over the bottom of the drain body.
9. With the tub now set in place. wipe off any excess tub or tile caulking, and adhesive where the
meets the floor with a wet cloth.
Floor Surface
PUTTY
9PAGE 10PAGE