Owner`s manual

INCOR POR ATED

Installation

ITC-Series Inverter Page 18 10/07/05

AC Input & Output Wiring

The AC wiring compartment is located on the front right side of the unit. A removable access cover covers this

compartment. Two cable clamps are installed for the AC input and AC output wiring. The removable access

cover can be removed by simply removing the screws on the front panel of the unit (ONLY!). There is no need

to remove screws from the top or sides of the unit to gain access to the AC wiring compartment. Inside the

compartment is a terminal strip for making AC input and AC output connections (P14 and P15).

NOTE

The AC output voltage and the required AC input voltage of the ITC is 120 VAC, 60Hz.

DC (Battery) Wiring

A DC wiring compartment is located behind the wiring panel on the right side of the unit. The compartment

contains a removable access cover on the top of the inverter and two cable clamps for the battery positive and

battery negative cables. The inverter‟s battery cable terminal studs are 5/16-18 and can accommodate Cable

sizes up to 250 MCM.

Front Panel Control/Display Outlet

This is a RJ-11 (6-Wire) jack (P5) for communications with the Control/Display Unit. A secondary

GND

OPTIONS TERMINAL STRIP

P14

HOT NEU GND

AC INPUT

P15

HOT NEU GND

AC OUTPUT

REMOTE MASTER AND

SLAVE CONNECTORS

REMOTE

SWITCH

REMOTE LED

COM N/O N/O

LOW BATT/

FAN ON

COM

GENSTART

BATTERY TEMP.

SENSOR