Owner`s manual

INCOR POR ATED
®
Installation
ITC-Series Inverter Page 5 Owner‟s Manual 10/7/05
Introduction
Thank you for purchasing the Vanner ITC-Series inverter/charger system. We are confident that you will be
satisfied with its performance and its many features. With proper installation and care, you can look forward to
years of service from this high performance product.
This document will describe the operation, technical specifications and installation procedures for the ITC-
Series inverter/charger system. If you require additional information please contact your dealer, or contact
Vanner directly at the location shown on the cover of this manual.
System Features and Specifications
General Description
The ITC-Series system consists of a DC to AC true sine wave inverter, a battery charger, an automatic AC
transfer switch, and a microprocessor based controller. An important feature of this system is the ITC-Series
Control/Display Unit user interface.
F 1 Figure 1.1-1 System Diagram
Control/Relay
Board
ITC Series Inverter System
AC Out 120 Vrms
Genstart Contact
120 Vrms Input for Charger
Control Display Panel
+12/24 VDC
Low Battery Indicator / Fan On Contact
Overload Overload
Low
Battery
Bulk
Fault Fault
Inverter
On/Off
Charger
On/Off
Fuse
12/24 Volt
Battery
CB-1
CB-2
Dead
Battery
Supply
Microprocessor
Control System
for Inverter/
Charger
On/Off Switch
Optional Remote Switch
GFCI
Signal
Relays
Power
Stage
Transformer
CB-3
30A
30A
15A