Owner`s manual

TSR-2 Remote Control
TruSine 4.5 kW Inverter Page 16 Owners Manual
+ XX ADC -
76 ↑ AbsorpChrgVolt ↓ Adjusts Absorption Charge DC Volts setpoint Go to Step 77
+ XX.XX VDC -
77 ↑AbsorpChrgAmps↓ Adjusts Absorption Charge DC Amps setpoint Go to Step 78
+ XX ADC -
78 ↑Absorp MaxTime ↓ Adjusts Absorption Charge maximum time Go to Step 79
+ XXX minutes - duration setpoint
79 ↑ FloatChrgVolts ↓ Adjusts Float Charge DC Volts setpoint Go to Step 80
+ XX.XX VDC -
80 ↑ Equalize Volts ↓ Adjusts Equalize Cycle DC Volts setpoint Go to Step 81
+ XX.XX VDC -
81 ↑ EqualizMaxTime ↓ Adjusts Equalize Cycle maximum time Go to Step 82
+ XX minutes - duration setpoint
82 ↑Batt Temp Comp ↓ Turns ON/OFF Battery Temperature Go to Step 83
ON off Compensation for Battery Charger
83 ↑ Batt Temp Coef ↓ Adjusts Battery Temperature Compensation Go to Step 84
+ XX.XmV/ºC/Cell - Coeficient
84 ↑BattTempShutDn ↓ Adjusts battery charger High Battery Temperature Go to Step 85
+ XXºC - shutdown setpoint
85 ↑ Gen Start Mode ↓ Allows Gen Start to operate automatically (ON) Go to Step 86
on OFF or turns Gen Start OFF.
86 ↑ GenStart Volts ↓ Adjusts battery voltage setpoint at which the Go to Step 87
+ XX.XX VDC - Gen Start contacts close
87 ↑ Gen Stop Amps ↓ Adjusts Bulk Charging amps setpoint at which Go to Step 88
+ XX ADC - the Gen Start contacts open
88 ↑ Aux AC Delay ↓ Sets time delay after Aux AC input power Go to Step 89
+ XXX Seconds - is present until AC transfer occurs
89 ↑ Solar Mode ↓ Allows inverter to operate in Solar Mode or Go to Step 70
on OFF turns Solar Mode OFF (DISABLED)
COMMMUNICATIONS Menu Used only for multiple inverter and/or multiple TSR-2 applications.
90 Look for Inverters? Starts automatic Remote configuration. If yes, go to
yes NO The default setting is NO. Step 91, If no
go to Step 92
91 Remote Addr: 1 Displays the addresses of the Remote(s) and
Inverter Addr: 1 the Inverter(s)
92 ↑ Inverter Addr: ↓ The Address of the system’s first inverter is 1. Go to Step 93
+ 1 - Do not change. See Demo Mode if changed.
93 ↑ Remote Addr: ↓ Sets the Remote address number. Go to Step 90
+ 1 - The remote address will match the inverter(s).