Owner`s manual

VANNER Incorporated Owner’s Manual
- 8 - 600 Watt VLT Series Inverter Owner’s Manual
Remote Control via customer-supplied SPST switch: If it is desired to remotely control the inverter from a
customer-supplied remote switch, remove the jumper connecting terminals Vout and Vin. Supply a 12v
(24v signal on 24v units) continuous signal to terminal Vin to turn the inverter ON. The source of the 12v
signal can be battery voltage for single-wire remote control or terminal Vout for two-wire-remote-control.
The most common remote control wiring arrangement uses a "hot in run" circuit from the vehicle fuse
panel for the 12v signal. This arrangement automatically turns the inverter ON when the vehicle is ON
and automatically turns the inverter OFF when the vehicle is OFF.
Green Connector Details: Terminal Vout is current limited, therefore if terminal Vout is used as the source
for the remote control signal, a fuse is not required in the remote control circuit. If Vout is not used as the
remote control signal, use a 5 amp fused circuit for the remote control signal.
The green connector can be removed from the inverter by pulling the connector outward. The two
upward facing screws are used to tighten the compression terminals for attachment of the signal wire(s).
Torque to 4 lb-in max
3.1.5 Measurements