Installation Guide

Board-N-Batten Shutter

Installation Instructions

I-0162

9-10-13

PC11428

Required for Installation:

Electric drill, 1/4" drill bit

For use on any surface including: wood, aluminum, vinyl, stucco, hardboard, brick, or masonry.

Step 1

Place the shutter next to the window and mark the desired

location against the wall or window. See figure at right.

Step 2

For sizes below 55" use four shutter loks per shutter. For larger sizes,

55" and over, use six shutter loks per shutter. See figures below for

proper shutter lok placement and hole size.

Step 3

Use the enclosed shutter loks to securely attach the shutter to the

wall surface. Do not over drive the fasteners. The shutters

need freedom to expand and contract with changing weather

conditions.

Four Shutter Loks

Application

For less than 55"

Six Shutter Loks

Application

For 55" or greater

1/4" holes

Note: The above instructions use the 3 board shutter as an

example. The same techniques will be used for

shutters with more boards.

Note: To prevent shutters from warping, proper installation must be followed.

1/8" holes

Arch Top

Application