Operation Manual

Chapter 5 >> Main Menu
22
English
Note
• What is Low Noise Block (LNB)?
The LNB is located at the satellite dish antenna. It amplies the very weak received
satellite signal then converts the received microwave satellite signal so that the signal
may not decrease the gain between the dish and your receiver.
 DiSEqC (Digital Satellite Equipment Control) Mode
You can select DiSEqC using the Arrow (◄/►) buttons.
You can select one mode among DiSEqC Port1~4 for 1.0 and Tone Burst 1~2 and Off.
 Tone 22KHz
In case you are using a dual LNB or two antennas connected to a 22KHz Tone Switch
Box, with 22KHz Tone Switch (On, Off, or Auto) you can switch between LNB or antenna.
 Motor
Select motor setting from DiSEqC, USALS, Positioner, and No.
 DiSEqC 1.1
In case of DiSEqC 1.1 usage, select port 1~16 for the satellites by using the Arrow
(◄/►) button.
 Signal Status
Press the blue button, you can check the signal status for each TP and Satellite with the
Arrow(◄/►▲/▼)buttons.
You can scan the selected satellite and TP and save the changes.
- Green button: Satellite Auto Scan
- Yellow button: TP Scan
4 After setting the option, press the OK or RED button to save.
• Select satellite(s) according to the direction of your satellite dish. You can select many
satellites depending on the direction to the satellites
5 Press the Back button to return to the Installation menu.
Anmerkung
• DiSeqC is the registered trademark of Eutelsat Communications.
A standard through which is possible to let a DiSEqC compatible receiver send a signal
over the RF cable to a switching device to switch between different LNBs or dishes. The
DiSEqC uses the 22KHz signal to control the switching device
Installation