Operation Manual

Chapter 5 >> Main Menu

English

Installation >> Tuner (1 or 2) >> Motor Settings

Motor Settings

 DiSEqC 1.2

If Motor is set to DiSEqC 1.2 in the Antenna

Setting men.

1 Select Motor Setting using the Arrow

(▲/▼) buttons and press the OK button.

2 Select a satellite using the Arrow (▲/▼)

buttons and press the OK button. Satellite

list appears.

Select satellite using the Arrow (▲/▼)

buttons and press the OK buttons.

Bulleted list indicates selected satellites.

3 Press the RED button to save selected satellites and then press the Back button.

4 If you press the YELLOW button, on-screen navigation menu is highlighted. Use the

Arrow buttons to move the motor to the west, east, north, and south in order. The

position of the motor can be restricted to the software setting limits (West/East) using

the RED / BLUE buttons.

5 Press the YELLOW button to highlight Satellite.

6 Press the OK button on the Go to satellite Menu. Dish changes its position to the

direction of satellite (depending on the types of motor, dish changes its position to the

default-direction of satellite for the maximum 28 satellites).

7 Press the OK button on the Save Current Position menu. Current position of the

motor is saved according to the selected satellite.

8 You can change the Function Menu (Go to Ref. Position / Reset Position / Calculate

Positions) by using the Arrow (◄/►) button, activate the function with OK button

- Go to Ref. Position: Press the OK button in the Go to Ref. Position menu. Motor

changes its position to zero longitude / latitude where the count begins.

- Reset Position: Reset Positioner initialize the position of motor to the default value.

- Calculate Positions: Calculate Positions selects one satellite to revise the position

of motor and saves the changes. Changed position of the motor also applies to the

directions for other satellites.

Installation