Operation Manual

Chapter 5 >> Main Menu
25
English
 Positioner
1 This function is used when receiving DiSEqC 1.2 Command with the adaptor that
controls positioner antenna. Select a satellite using the Arrow (▲/▼) buttons and
press the OK button. Satellite list appears.
On the satellite list, you can select satellites
pressing the OK button. Press the RED
(Last) button to save the selected satellites.
2
If you press the YELLOW (Audio) button, on-
screen navigation menu is highlighted. Use
the Arrow (▲/▼/◄/►) buttons to move the
motor to the west, east, north, and south in
order. Position of the motor can be restricted
to the software setting limits (West/East)
using the RED / BLUE buttons.
3
Press the OK button on the Go to satellite menu. Dish changes its position to the
direction of satellite.
4
Press the OK button on the Save Current Position menu. Current position of the
motor is saved according to the selected satellite.
5
Press the OK button on the Go to Ref. Position menu. Motor changes its position to
the zero longitude/latitude where the count begins. (this function is not supported by
the adaptor that controls positioner antenna)
6
Go to Reference changes the position of control adaptor.
7
Reset Positioner initializes the position of motor to the default value.
8
You can change the function Menu (Go to Ref. Position / Reset Position / Calculate
Positions) by using the Arrow (◄/►) button, activate the function with OK button
- Go to Ref. Position: changed position of the motor also applies to the directions for
other satellites.
- Calculate Positions: Conrm the Enable Limits/Disable Limits function pressing
the OK button. This function may not be supported depending on the model.
9
The method to position motor is selected on the Continuous / Step (Impulses) / Time
(Seconds) menu, If you press the Arrow (◄/►) button once on the Continuous mode,
selected TP signal of the satellite is locked or the motor stops to move.
On the Step (Impulses) mode, you can select steps (pulse) from 1 to 10. The
motor changes its position according to the selected step if moved to the left or right
(depending on the motor).
On the Time (Seconds) mode, you can select time (seconds) from 1 to20. the
motor changes its position according to the selected step if moved to the left or right
(Depending on the motor).
If you have a MOTEK motor please use positioned menu instead of DiSEqC 1.2. to make
sure that your motor is working correct.
Installation