Technical Specs

7 / 18
The phone lock code may be set to prevent your mobile phone from being misused. In general,
this code is provided along with the mobile phone by the manufacturer. The initial phone lock code
is set to 1234 by the manufacturer. If the phone lock code is set, you need to input the phone lock
code when powering on the mobile phone.
 PIN
The PIN (Personal identification number, 4 to 8 digits) code prevents your SIM card from being
used by unauthorized people. In general, the PIN is supplied with SIM card by the network operator.
If PIN check is enabled, you need to input the PIN each time when you power on your mobile
phone. The SIM card will be locked if you input wrong PIN code for three times.
Unlocking methods as follows:
-Input the correct PUK according to the screen tips to unlock the SIM card.
-Then input the new PIN and press the OK key.
-Input the new PIN again and then press the OK key.
-If the input PUK is correct, the SIM card will be unlocked and the PIN will be reset.
Note: The SIM card will be locked if you input wrong PIN code for three times. To unlock the
SIM card, you need to input the PUK. In general, the PUK can be obtained from the network
operator.
 PUK
The PUK code (Personal Unlocking Key) is required to change a blocked PIN. It is supplied
with SIM card. If not, contact your network operator. If you input wrong PUK code for 10 times,
SIM card will be invalid. Please contact the network operator to replace the SIM card.
 Barring code
A barring code is required for setting the call barring function. You can obtain this code from
the network operator to set the call barring function.
3.2 Installing T-Flash Card
The T-Flash card is a pluggable mobile storage card inside the mobile phone.
To install the T-Flash card, place its indented side downward, insert the card into the card slot,
till cannot push in.
To remove the T-flash card, slightly take the card out, finish remove.
Note:
1. The mobile phone cannot automatically identify the T-flash card being inserted when the mobile
phone is powered on. You must power off the mobile phone and then power it on, so that the phone
can identify the T-Flash card.
2. The T-Flash card is a miniature object. Keep it out of the reach of children for fear that children
swallow it!
3.3 Charging the Battery
The lithium battery delivered with the mobile phone can be put into use immediately after being
unpacked.
Battery level indication:
 Your mobile phone can monitor and display the battery state.
 Normally the remaining energy of the battery is indicated by the battery level icon at the
upper right corner of the display screen.
 When the battery energy is insufficient, the mobile phone prompts "Battery low". If you have