User's Manual

Notice

Considering that reasonable efforts have been made to assure accuracy of this

manual, Vantron assumes no responsibility of possible missing contents and

information, errors in contents, citations, examples, and source programs.

Vantron reserves the right to make necessary changes to this manual without prior

notice. No part of this manual may be reprinted or publicly released in forms of

photocopy, tape, broadcast, e-document, etc.

FCC compliance statement

this device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Note 1: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

NOTE 3: Operation in the band 5150–5250 MHz is only for indoor use to reduce the

potential for harmful interference to co-channel mobile satellite systems.

RF exposure information and statement: this device meets government requirements

for exposure to radio waves. The guidelines are based on standards that were developed