Manualshelf

User Manual

ManualsBrandsVANTRUE ManualsCar & Vehicle ElectronicsN2 Uber Dual Dash Cam, 1080P Inside and Outside Dual Dash Camera, 1.5 inches LCD, Near 360 Degree Wide Angle Lyft Dual Car Cam with Parking Mode, Motion Detection, Front Camera Night Vision
11121314151617181920
M
!
P
OK
After inserting a memory card, the camera will (by default) immediately
start loop recording video when connected to a power source and
poweredON. If the device is not connected to a power source, it
will not immediately start recording after you press the Power ON
button – press the OK button to start recording.
While recording, the LED indicator will blink and a red dot will flash
on the top left of the screen. You can stop/start the recording at
any time by pressing the OK button.
4.4 Loop Recording
By default, the Loop Recording Time is 5 minutes. Please go to
“Record Setup”>“Loop Recording” to change it to 1 minute,
3 minutes, or 10 minutes. When Loop Recording is turned off, the
camera will record video in 30 minute clips, but will not overwrite
old videos when the storage card is full.
The loop recording video file name format is “Year_Date_Time_
SerialA”. For example:“2017_0101_060101_001A”, the suffix A
indicates front cam recorded files, while the suffix B refers to rear
cam recorded files). Standard files are stored in the “Video/Normal”
folder. When the microSD card is full, the camera will write over
older files.
Critical event detection is triggered by the G-Sensor (Gravity Sensor)
4.5 Event Recording
- 11 -