User's Manual

ADCP-75-163SDR • Issue 1 • September 2004
Page 12
© 2004, ADC Telecommunications, Inc.
1. Slip on an Electro-Static Discharge (ESD) wrist strap and connect the ground wire to an
earth ground source. Wear the ESD wrist strap while completing the optical transceiver
installation procedure.
2. Locate the appropriate transceiver socket on the front of the SDR card as shown in
Figure 5 and remove the cover from the socket.
3. Select optical transceivers shown in Figure 5.
Figure 5. Optical Transceiver Installation
Warning: Electronic components can be damaged by static electrical discharge. To prevent
ESD damage, always wear an ESD wrist strap when handling electronic components.
Note: A variety of optical transceivers are available, all provide the same functionality. On
the type A optical transceiver, the release lever (see
Figure 5 ) must be closed for
installation.
19312-A
TYPE A
TRANSCEIVER
TYPE B
TRANSCEIVER
TYPE C
TRANSCEIVER
RELEASE
LEVER
RELEASE
TAB
RELEASE
BAR
DUST
CAPS