Installation Sheet

WARNING: FOR YOUR PROTECTION AND SAFETY -
KEEP THESE INSTALLATION INSTRUCTIONS GUARDE ESTAS INSTRUCCIONES DE INSTALACIÓN
Carefully read and
understand the information given in this manual before beginning the assembly and
installation. Failure to do so could lead to electric shock, re or other injuries which
could be hazardous or even fatal. PRODUCT MUST BE INSTALLED BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE.
Saftey Instructions Instrucciones de seguridad
1. All electrical connections must be in agreement with local codes, ordinances or
the national electric code (NEC). Contact your municipal building department to learn
about your local codes, permits and/or inspections. WARNING: RISK OF FIRE - MOST
DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED FOR 60°C. CONSULT A
QUALIFIED ELECTRICIAN BEFORE INSTALLATION.
2. TURN OFF ELECTRICITY at main fuse box (or circuit breaker box) before beginning
installation by switching circuit breaker o or removing fuse.
3. DO NOT connect this xture to an electrical system that does not provide a
means for equipment grounding. Never use a xture in a two-wire system that is not
grounded. WARNING: INSTALLING A FIXTURE INTO AN ELECTRICAL SYSTEM NOT
HAVING A PROPER GROUNDING MEANS COULD ALLOW ALL METAL PARTS OF
THE FIXTURE TO CARRY ELECTRICAL CURRENT IF ANY OF THE FIXTURE WIRES,
WIRE CONNECTIONS OR SPLICES BECOME BROKEN, CUT OR LOOSE DURING THE
MOUNTING OR NORMAL OPERATION OF THE FIXTURE, UNDER THIS CONDITION,
ANYONE COMING IN CONTACT WITH THE FIXTURE IS SUBJECT TO ELECTRICAL
SHOCK, WHICH COULD CAUSE SERIOUS INJURY OR DEATH.
4. If you are not sure your lighting system has a grounding means, DO NOT attempt
to install this xture. Contact a qualied, licensed electrician for information with
regards to proper grounding methods as required by the local electrical code in your
area.
current carrying wire or white neutral house wire. WARNING: CONNECTION OF THE
BARE OR GREEN FIXTURE GROUND WIRE TO THE BLACK OR WHITE HOUSE WIRES
MAY ALLOW ALL METAL PARTS OF THE FIXTURE TO CARRY ELECTRICAL CURRENT.
UNDER THIS CONDITION ANYONE COMING IN CONTACT WITH THE FIXTURE WILL
RECEIVE ELECTRICAL SHOCK, WHICH COULD CAUSE SERIOUS INJURY OR DEATH.
6. DO NOT suspend any xture by the house wires. A xture must always be mounted
directly to an outlet box or to a mounting strap which is rst attached to the outlet
box. WARNING: WIRE CONNECTORS WILL NOT SUPPORT THE WEIGHT OF A
FIXTURE. SUSPENDING A FIXTURE BY THE HOUSE WIRES AND WIRE CONNECTORS
WILL RESULT IN THE FIXTURE FALLING, WITH THE POSSIBILITY OF PERSONAL
INJURY AND THE DANGER OF ELECTRICAL SHOCK OR FIRE.
7. All xtures must be mounted to an outlet box that is supported by the building
structure. DO NOT attempt to support the xture by ceiling board alone. Ceiling
board alone does not have the strength to support the weight of the xture. The xture
may fall and cause personal injury.
8. BE CAREFUL not to damage or cut the wire insulation (covering) during xture
installation. DO NOT permit wires to contact any surface having a sharp edge. To do
so may damage or cut the wire insulation which could cause serious injury or death
from electric shock.
9. DO NOT use lamps (bulbs) having a greater wattage than the maximum value
stated on the xture. The use of a higher wattage lamp(s) than specied will increase
temperatures and cause the risk of re.
10. If a dimmer control switch is used with this xture, obtain professional advice to
determine the correct type and electrical rating required.
ADVERTENCIA: PARA SU PROTECCION Y SEGURIDAD- Lea cuidadosamente
y obtenga una clara idea de la información en este manual antes de iniciar el
ensamblaje e instalación descrita en las páginas que siguen. El ignorar esto podría
causar un choque eléctrico, incendio u otros daños que pueden ser peligrosos y hasta
fatales. PRODUCTO DEBE SER INSTALADO POR UN FAMILIAR CON LA CONSTRUCCIÓN
Y EXPLOTACIÓN DEL PRODUCTO Y LOS PELIGROS QUE PARTICIPAN DE ACUERDO CON EL
CÓDIGO DE INSTALACION CORRESPONDIENTE.
1. Todas las conexiones eléctricas deben estar de acuerdo con el código y las
ordenanzas locales, o el código eléctrico nacional (NEC, siglas en inglés). Póngase
en contacto con el departamento de construcción de la municipalidad para ilustrarse
respecto a los códigos, licencias y/o inspecciones locales. ADVERTENCIA: RIESGO
DE INCENDIO - LA MAYORIA DE EDIFICIOS CONSTRUIDOS ANTES DE 1985 TIENEN
CABLES DE ALIMENTACION CON CAPACIDAD TERMICA NOMINAL DE 60°C.
CONSULTE CON UN ELECTRICISTA CALIFICADO ANTES DE LA INSTALACION.
2. CORTE LA ELECTRICIDAD en la caja principal de fusibles (o la caja del interruptor
automático) antes de comenzar la instalación, apagando el interruptor o quitando el
fusible.
3. NO CONECTE este artefacto a un sistema eléctrico que no tiene conexión a tierra.
Nunca use un artefacto en un sistema eléctrico de dos cables sin conexión a tierra.
ADVERTENCIA: EL INSTALAR UN APARATO EN UN SISTEMA SIN CONEXION A
TIERRA APROPRIADA, PODRIA CAUSAR QUE TODAS LAS PARTES METALICAS DEL
APARATO SE ELECTRIFIQUEN. SI SUCEDE QUE CUALQUIERA DE LOS CABLES
DEL APARATO, LAS CONEXIONES O EMPALMES SE ROMPAN, SE CORTEN O SE
SUELTEN DURANTE EL ENSAMBLAJE O LA OPERACION DEL APARATO, ENTONCES
CUALQUIER PERSONA QUE SE PONGA EN CONTACTO CON EL APARATO ESTA EN
PELIGRO DE RECIBIR UN CHOQUE ELECTRICO QUE PUEDE CAUSAR LESIONES
GRAVES Y AUN LA MUERTE.
4. Si usted no está seguro de que su sistema de alumbrado tiene medios para
cone
xión a tierra, NO INTENTE instalar este aparato. Contacte a un electricista
conexión a tierra requerida por el código eléctrico de su localidad.
5. NO CONECTE el cable a tierra desnudo o el de aislamiento verde, al negro
(POSITIVO) portador de la electricidad o al blanco neutro proveniente de la casa.
ADVERTENCIA: EL CONECTAR EL CABLE A TIERRA DESNUDO O EL VERDE DEL
APARATO, AL CABLE NEGRO O AL BLANCO DE LA CASA, PUEDE HACER QUE
TODAS LAS PARTES METALICAS DEL APARATO SE ELETRIFIQUEN. BAJO ESTAS
CONDICIONES CUALQUIER PERSONA QUE SE PONGA EN CONTACTO CON EL
APARATO RECIBIRA UN CHOQUE ELECTRICO QUE PUEDE CAUSAR LESIONES
GRAVES Y AUN LA MUERTE.
6. NO CUELGUE ningún aparato de los alambres eléctricos de la casa. Un aparato
siempre debe montarse directamente a una caja de salida o a una barra para artefactos
previamente montada sobre la caja de salida. ADVERTENCIA: LOS CABLES DE
CONEXION NO SOPORTARAN EL PESO DE UN APARATO. EL COLGAR DE LOS
CABLES DE LA CASA Y LOS CONECTORES RESULTARA EN LA CAIDA DEL APARATO
Y LA POSIBILIDAD DE LESIONES PERSONALES Y EL PELIGRO DE CHOQUE
ELECTRICO O INCENDIO.
7. Todos los aparatos deben sujetarse a una caja de salida que esté sujeta a la
cielo raso no tiene la fuerza para soportar el peso del aparato. El aparato se puede
caer y causar lesiones personales.
8. TENGA CUIDADO de no dañar o cortar el aislamiento (la cubierta) del cable
durante la instalación del aparato. NO PERMITA que los cables estén en contacto con
del cable, lo que podría causar serios daños o la muerte por choque eléctrico.
9. NO USE bombillas (focos) de mayor cantidad de vatios que el máximo mencionado
temperatura y provocará un riesgo de incendio.
10. Si se utiliza un reductor de intensidad de luz con este aparato, obtenga asesoría
profesional para determinar el tipo correcto y el amperaje necesario.
Questions, problems, missing parts? Contact our Customer Care Center: 1-702-792-6900
Tiene preguntas, problemas, o faltan partes? Comuníquese con nuestro centro de Atención al Cliente: 1-702-792-6900
Page 2 of 4
Página 2 de 4