Manual

Preparing the system for nale installation
Installing the Air meter into the Air box-
Redhoses-youwillndthefallowinghosesone2inch(4inchID)one1inch(3.5IDforsliptting
onto MAF meter )
1. Install the air meter directly into the air box neck, counter sink this, we set its length for just this
purpose, it should slide in tight . Put one hose clamp on and tighten, NOTE you will retighten this
later after you heat soak the engine compartment after the installation.
2. Oneinchlong3.5IDredhose-slidethisontothetailoftheairmeter.Youareusingthisasaslipt.
3.Installthe4.0IDhosewithPCVttingontothethrottlebody(PCVttingshouldbeatthe11
O’clock position when standing facing the motor.)
Tech note: after installing hose slide the hose clamp as far forward as possible on the throttle body
casting to ensure that there is a smooth transition from the inside of the hose to the throttle body casting.