Technical Specifications

T E C H N I C A L D A T A
Rev. 08/05
Printed in USA
1 of 3
VARATHANE
®
PREMIUM FLOOR CLEAR FINISH
OIL BASED
DESCRIPTION AND USES
PRODUCT APPLICATION
Varathane Floor Finish is specifically developed to enhance the
natural beauty of wood while providing the best scratch and
stain resistance available. When it comes to polyurethanes, one
formula does NOT fit all projects. Only Varathane offers
application specific formulations:
Application Protection
Diamond Wood Finish Scratch and Stain
Diamond Floor Finish Scuff and Scratch
Diamond Outdoor Finish UV Protection &
Weatherability
Varathane Floor Finish is ideal all flooring applications. Over
twice as durable as traditional wood finishes, Floor Finish adds
a warm, golden glow to your project. It has the fastest dry time
of any oil-based polyurethane and is self leveling to save you
time.
PRODUCTS
RECOMMENDED COMPANION PRODUCTS
Recommended use with Varathane Premium Oil Stains.
Varathane Premium Oil Stains are available in 24 colors
and 4 different sizes (Trial Packets, 236mL, 946mL and
3.78L). Use the Varathane Trial Packets to sample
different colours.
PREVIOUSLY FINISHED SURFACES
For best adhesion, surfaces must be clean, dry, and free of old
finishes, dust, dirt, oils, or foreign matter. Old finishes in poor
condition must be removed. Sand to obtain a smooth surface.
Remove all sanding dust using a vacuum or cloth dampened
with mineral spirits.
STAINED OR PAINTED WOOD
Follow manufacturer’s direction for application of stain or
paint. Make certain surface is thoroughly dry before applying
Varathane Floor Finish. Refer to manufacturer’s label for dry
times. For best results, use Varathane Premium Wood Stains.
UNFINISHED SURFACE PREPARATION
Sand using 36, 50, and finish with 80 grit sandpaper and
remove all sanding dust using a rag dampened with mineral
spirits, or vacuum. If a filler or putty is used, make sure that it
does not contain wax and allow for enough time to dry
thoroughly.
APPLICATION TIPS
Use adequate ventilation at all times. Apply only when the air
and surface temperatures are above 13°C (55°F), and below
32°C (90°F). Slower dry times may result from applications on
redwood, cedar, or woods with high oil content, use of stain or
sealer, or periods of high humidity and/or low temperatures.
Use full strength. To prevent bubbles in the finish, do not over-
brush, shake, or apply with a roller. Varathane Floor Finish has
a slight amber cast. Test Varathane Floor Finish in an
inconspicuous area. Testing is particularly important when
applying over paints or stains as the appearance of these
products may change slightly when an oil-based finish is
applied.