Technical Specifications

1 of 3
T E C H N I C A L D A T A
VARATHANE
®
INTERIOR DIAMOND POLYURETHANE
WATER BASED
DESCRIPTION AND USES
PRODUCT APPLICATION
Varathane Diamond Polyurethane provides protection for your
wood that is diamond hard, diamond clear, and diamond
beautiful. Varathane Diamond Polyurethane is specifically
developed to enhance the natural beauty of wood while
providing the best scratch and stain resistance available.
When it comes to polyurethanes, one formula does NOT fit all
projects. Only Varathane offers application specific
formulations. For wood floors use Varathane Floor Finishes to
protect against heavy foot traffic. For Outdoor projects use
Varathane Spar Urethane with powerful UV absorbers to guard
against sun damage.
Varathane Interior Polyurethane is ideal for all interior stained ,
bare, or painted projects such as furniture, doors, cabinets, and
trim. Over twice as durable as traditional wood finishes, It has
the fastest dry time of any oil-based polyurethane and is self
leveling to save you time.
ECOMMENDED COMPANION PRODUCTS
Recommended use with Varathane Premium Oil Stains,
Gel Stains, and Universal Sanding Sealer.
Varathane Premium Oil Stains are available in 24 colors
and 4 different sizes (Trial Packets, Half-Pints, Quarts, &
Gallons). Use the Varathane Trial Packets to sample
different colors.
Varathane Premium Gel Stains are available in 10 colors
and 2 different sizes (Half-Pints & Quarts).
Varathane Premium Sanding Sealer seals woods poors and
is easy to sand. It is available in quarts and gallons.
PREVIOUSLY FINISHED SURFACES
For best adhesion, surfaces must be clean, dry, and free of old
finishes, dust, dirt, oils, or foreign matter. Old finishes in poor
condition must be removed. Sand to obtain a smooth surface.
Do not use steel wool as rust may develop after finish has been
applied. Remove all sanding dust using a vacuum or cloth
dampened with mineral spirits.
STAINED OR PAINTED WOOD
Follow manufacturer’s direction for application of stain or
paint. Make certain surface is thoroughly dry before applying
Varathane Diamond Polyurethane. Refer to manufacturer’s
label for dry times. For best results, use Varathane Premium
Wood Stains.
UNFINISHED SURFACE PREPARATION
Sand using 150-220 grit sandpaper and remove all sanding dust
using a rag dampened with mineral spirits, or vacuum. If a
filler or putty is used, make sure that it does not contain wax
and allow for enough time to dry thoroughly.
APPLICATION TIPS
Product appears milky when wet but dries to a crystal clear
finish. Use adequate ventilation at all times. Do not apply in
direct sunlight. Apply only when the air and surface
temperatures are above 55°F, and below 90°F. Use care when
applying over white or pastel paints or stains as discoloration
may occur. To prevent bubbles in the finish, do not over-brush,
shake, or apply with a roller. Test Varathane Diamond
Polyurethane in an inconspicuous area before beginning.
APPLICATION (Aerosol)
1.) Shake can vigorously before and during use.
2.) Use a drop cloth or newspapers to protect surrounding
areas from spray mist
3.) Spray light mist coats, holding can 10-12 inches from
surface. Move can with a smooth sweeping motion to
avoid runs and sags. Several light coats give a better
finish than one heavy coat.
4.) Allow finish to dry then re-coat. Dries to the touch in
30 minutes, recoat after 1 hour. For extra smoothness,
sand lightly with fine grit (#220) sandpaper before
final coat.
Rev. 03/06
Printed in USA