Specification

1 of 3
PREVIOUSLY FINISHED SURFACES
For best adhesion, surfaces must be clean, dry, and free of wax,
grease, oil, shellac, lacquer, mildew, and polishes. Remove wax
with wax stripper, shellac with a paint stripper, and mildew
with a solution of up to 10% household bleach and tap water.
Old finishes in poor condition must be removed. Sand to obtain
a smooth surface. Do not use steel wool as rust may develop
after finish has been applied. Remove all sanding dust using a
vacuum or cloth dampened with mineral spirits.
STAINED OR PAINTED WOOD
Follow manufacturer’s direction for application of stain or
paint. Make certain surface is thoroughly dry before applying
Varathane Diamond Spar Urethane. Refer to manufacturer’s
label for dry times. For best results, use Varathane Premium
Wood Stains.
UNFINISHED SURFACE PREPARATION
Sand smooth using 120-150 grit sandpaper and remove all
sanding dust using a rag dampened with mineral spirits, or
vacuum. If a filler or putty is used, make sure that it does not
contain wax and allow for enough time to dry thoroughly.
APPLICATION TIPS
Product appears milky when wet but dries to a crystal clear
finish. Use adequate ventilation at all times. Do not apply in
direct sunlight. Apply only when the air and surface
temperatures are above 55°F, and below 90°F. Use care when
applying over white or pastel paints or stains as discoloration
may occur. To prevent bubbles in the finish, do not over-brush,
shake, or apply with a roller. Test Varathane Diamond Spar
Urethane in an inconspicuous area before beginning. Testing is
particularly important when applying over paints or stains as
the appearance of these products may change slightly when a
water-based finish is applied.
APPLICATION (Aerosol)
1.) Shake can vigorously before and during use.
2.) Use a drop cloth or newspapers to protect surrounding
areas from spray mist
3.) Spray light mist coats, holding can 10-12 inches from
surface. Move can with a smooth sweeping motion to
avoid runs and sags. Several light coats give a better
finish than one heavy coat.
Varathane Diamond Spar Urethane provides the ultimate
protection for all your outdoor wood projects in an easy to use,
water-based formula. Varathane Diamond Spar Urethane has
been specifically formulated to provide the best protection from
UV light and weather, which can take years off the life of your
outdoor wood.
When it comes to polyurethanes, one formula does NOT fit all
projects. Only Varathane offers application specific
formulations. For wood floors use Varathane Floor Finishes to
protect against heavy foot traffic. For Outdoor projects use
Varathane Spar Urethane with powerful UV absorbers to guard
against sun damage.
Varathane Diamond Spar Urethane is ideal for all types of
outdoor projects, from outdoor furniture to doors and window
trim. Varathane Diamond Spar is crystal clear, virtually
odorless, and provides for easy water clean-up.
Type
Satin
Semi-Gloss
Gloss
Spray
250281
250181
250081
Pint
250251
250151
250051
Quart
250241
250141
250041
Gallon
250231
250131
250031
5 Gallon*
250221
*Available as special orders only
T E C H N I C A L D A T A
VARATHANE
®
OUTDOOR DIAMOND SPAR URETHANE
WATER BASED
PRODUCTS
DESCRIPTION AND USES
PRODUCT APPLICATION
Rev. 03/06
Printed in USA