Specification

TECHNICAL DATA VAR-41
VARATHANE
®
STAIN + POLY
Form: GDH-752
Rev.: 031315
1
.DESCRIPTION AND USES .
Varathane
®
Water-based One Step Stain & Polyurethane
is a convenient product for staining and finishing. This
combination of stain and polyurethane into one product
allows projects to be finished quickly in one easy step with
the ease of soap and water clean-up.
Rich, deep colors are achieved with premium pigments to
provide a durable semi-gloss finish. Varathane Stain +
Poly can be used on all interior wood projects including
furniture, trim, cabinets and doors. Not recommended for
floors or outdoor surfaces.
FEATURES .
 Rich even color
 Excellent scratch resistance
 Soap and water clean-up
.
PRODUCTS .
SKU Description
266151 1-Quart Cabernet
266152 1-Quart Summer Oak
266153 1-Quart Kona
266154 1-Quart Early American
266155 1-Quart Black Cherry
266159 1-Quart Dark Walnut
266160 1-Quart Golden Oak
266162 1-Quart American Walnut
266164 1-Quart Traditional Cherry
266171 1-Quart Light Walnut
.PRODUCT APPLICATION .
SURFACE PREPARATION
Proper surface preparation is important. Please follow
instructions thoroughly. Surfaces must be clean, dry
and sound. Remove any existing finishes with sandpaper
or stripper. Prepare bare wood for staining by sanding in
the direction of the grain. Begin with #150 grit sandpaper
and progress through #180 and #220 grits. Before using
product, remove all sanding dust with a vacuum or a
clean rag dampened with mineral spirits.
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
.PRODUCT APPLICATION (cont.) .
TESTING COLOR
Be sure to test Varathane Water-based One Step Stain +
Polyurethane to verify the desired color. To test, apply the
stain in an inconspicuous area. For a deeper color,
additional coats may be required.
APPLICATION
Stir the contents thoroughly before use. DO NOT SHAKE.
Use when temperatures are between 50-90°F (10-32°C)
and humidity is less than 85%. Allow longer dry times for
damp, humid days. Apply a thin coat until a uniform film
has been achieved. To prevent brush marks, avoid
excessive brushing. Some grain raise may occur. If so,
lightly sand the surface using 220 grit sandpaper. Wipe off
sanding dust. Apply a second coat. Additional coats can
be applied with one hour dry time between coats. Lightly
sand between coats with 320 grit sandpaper. Two to three
coats are recommended. REMOVE ALL SANDING DUST
BEFORE APPLYING ADDITIONAL COATS.
COVERAGE
Each quart will cover approximately 100-125 square feet.
Coverage may vary depending on the applicator and the
porosity of the wood.
DRY TIME
Dry times are based on 70°F and 50% relative humidity.
For best results allow stain to dry at least 1 hour then
apply Varathane Polyurethane.
CLEAN-UP
Clean application tools and equipment with soap and
water.