Technical Specifications

TECHNICAL DATA
VAR-104
VARATHANE
®
AGED WOOD ACCELERATOR
1
Form: ARJ-2114
Rev.: 092420
DESCRIPTION AND USES
Varathane
®
Aged Wood Accelerator creates an aged look on
bare or untreated wood. It replicates the aging process that
occurs in nature by reacting with the tannins of the wood to
create a unique one-of-a kind rustic brown. It works on all
types of wood. The final look will vary on the wood type. This
water-based formula is low odor.
Not for use on outdoor surfaces. For wood substrates only.
Not recommended for floors.
PRODUCT
DESCRIPTION (Quart)
SKU
Aged Wood Accelerator
331305
PRODUCT APPLICATION
SURFACE PREPARATION
Remove any existing finishes with sandpaper or liquid
stripper. Aged Wood Accelerator works best on bare or
untreated wood. Prepare bare wood by sanding in the
direction of the grain with #100 grit sandpaper. Remove any
dust with a clean, dry rag.
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE.
Wear a NIOSH-approved respirator to control lead exposure.
Clean up carefully with a HEPA vacuum and a wet mop.
Before you start, find out how to protect yourself and your
family by contacting the National Lead Information Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead.
TESTING COLOR
Aged Wood Accelerator reacts differently with different types
of wood. To verify the final look, test Aged Wood Accelerator
in an inconspicuous area first.
PRODUCT APPLICATION (cont.)
APPLICATION
Stir or shake material thoroughly before and occasionally
during use. For best results, use at temperatures between
60ºF (16ºC) and 90ºF (32ºC). Apply with a synthetic bristle
brush or foam brush. Allow Aged Wood Accelerator to sit on
the wood for 30 minutes to 1 hour for the final effect. Wiping
away is not required. For a lighter effect, apply product and
wipe away immediately or lightly sand the finish with fine grit
sandpaper once it is dry. To darken, a second coat can be
applied after 1 hour. To remove Aged Wood Accelerator,
apply bleach to the surface and wipe off.
PROTECTING THE FINAL FINISH
A topcoat should be applied for the best protection. Wait 2
hours for Aged Wood Accelerator to dry. For surfaces such as
furniture and cabinetry, a lacquer spray can be used as the
topcoat. For best results, use Watco lacquer. If you choose to
topcoat with a polyurethane, first seal with Watco Lacquer
spray and then apply Varathane Polyurethane. Test in an
inconspicuous area first. Some topcoats may continue to
react with the Aged Wood Accelerator affecting the final work.
COVERAGE
Each quart will cover up to 275 square feet.
CLEAN UP
Soap and water.