TDS
STAIN
TECHNICAL DATA VAR-27
VARATHANE ONE-STEP
STAIN & POLYURETHANE
Form: GDH-756
Rev.: 030817
1
.DESCRIPTION AND USES .
Varathane
®
One-Step Stain & Polyurethane allows the user to
both stain and protect their wood surfaces in one easy
application. This innovative, oil-based formula provides deep, rich
color and polyurethane finish in one easy step. By combining a
stain with polyurethane, the need for multiple product application
is eliminated and wood surfaces are enriched with a deep, rich
beautiful color and protected by long lasting polyurethane. Use
on all interior projects including: intricate moldings, wood furniture,
trim, cabinets, doors and paneling.
Available in eight distinct colors Varathane One-Step Stain &
Polyurethane offers an easy and convenient alternative to the
traditional method of staining and protecting
.PRODUCTS .
SKU Description
225243H 1-Quart Golden Pecan
225244H 1-Quart Golden Oak
225245H 1-Quart Provincial
225246H 1-Quart Cherry
225247H 1-Quart Red Mahogany
225248H 1-Quart Cabernet
225249H 1-Quart Early American
225250H 1-Quart Dark Walnut
.RECOMMENDED COMPANION PRODUCTS .
Varathane Premium Sanding Sealer seals wood’s pores and is
easy to sand. It is available in quarts and gallons.
Varathane Wood Conditioner is an essential step to ensure a
uniform finish on soft woods that have an uneven grain structure
like pine, fir, alder, and birch. It is available in half-pints, quarts
and gallons.
.PRODUCT APPLICATION .
SURFACE PREPARATION
Remove any existing finishes with sandpaper or stripper.
Prepare bare wood for product application by sanding in the
direction of the grain. Begin with #120 grit sandpaper and
progress through #150, #180 and #220 grits.
Before staining, remove all sanding dust, dirt, grease or glue with
a vacuum or clean rag dampened with mineral spirits.
..PRODUCT APPLICATION (cont.) .
SURFACE PREPARATION (cont.)
WARNING! If you scrape, sand or remove old paint, you may
Release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS SUCH AS BRAIN
DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a
HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
TESTING COLOR
Be sure to test Varathane One-Step Stain & Polyurethane to
verify the desired color. To test, apply in an inconspicuous area.
For a deeper color, additional coats may be applied.
APPLICATION
Stir the contents thoroughly before use. Do not shake.
Use adequate ventilation at all times. Apply only when air
(ambient) temperature is between 55-90°F (13-32°C) and the
relative humidity is below 85%. Apply using a good quality,
natural bristle brush or applicator, brush in the direction of the
grain until a uniform film has been achieved. To prevent brush
marks, avoid excessive brushing. Additional coats can be
applied with one hour dry time between coats. Lightly sand
between coats with #320 grit sandpaper. Remove all sanding
dust before applying additional coats.
CLEAN-UP
Clean application tools and equipment with mineral spirits or
paint thinner. Dispose of unused contents in accordance with
local, state and feral regulations.