SDS

SAFETY DATA SHEET
Filename: Mix 140 Wood Putty SDS Documents #: SDS-M140
Issue Date: 5/3/17 Approved By RKL_________
Revision: 8 Page 6 of 13
Body: Protective equipment for body should be selected based on the task being performed and
the risks involved. Safety shower accessibility.
Eye Protection: Eye protection in the form of protective glasses or goggles is recommended.
Eyewash facility accessibility.
Hygiene Measures: Do not eat, drink or smoke when using this product. Wash hands and
contacted areas with soap and water before taking breaks and after completing
work. Observe good industrial and personal hygiene practices. Remove and
wash contaminated clothing prior to re-use.
Section 9- Physical and Chemical Characteristics
Physical State: Colored Paste Odor Threshold: Not determined
Appearance Varies in color Odor: Slight odor
Vapor Pressure: Not determined Flash Point: Not determined
Water Solubility: Partial pH 8.0-9.0
Vapor Density (Air =1): Not determined Specific Gravity: 1.4-1.7 (water =1)
Evaporation Rate (Water =1): Not determined Freezing Point: Not determined
Melting Point: Not determined Relative Density: Not determined
Flammability (solid, gas): Not determined
Autoignition Temperature: Not determined
Decomposition Temperature: Not determined
Flammable Limits: Lower: Not Available Upper: Not Available
Partition coefficient: n-octanol/water: Not determined
Initial Boiling Point and Boiling Range: Variable
Percent Volatile: Not determined
Volatile Organic Compounds (V.O.C.): 0. 4% by weight
Section 10- Stability and Reactivity
Chemical Stability: Stable (Avoid temperatures above 177
0
C/350
0
F)
Conditions to Avoid: Excessive heat and freezing temperatures
Incompatible Materials: None known
Hazardous Decomposition Products: Oxides of carbon, trace ammonia.
Under normal conditions of storage and use, hazardous decomposition
products should not occur.
Reactivity: Non-reactive when product is used in accordance with intended use.
Possibility of Hazardous Reactions: Under normal conditions of storage and use, hazardous reactions will
not occur.
Hazardous Polymerization: Will not occur
Section 11– Toxicological Information
NOTE: The information below may not be consistent with the material classification in Section 2 if specific
ingredient classifications are mandated by a competent authority. In addition, toxicological data on ingredients may
not be reflected in the material classification and/or the signs and symptoms of exposure, because an ingredient may