Technical data
17.12.2004 Rev. 2.0
Adjustment instructions
13
On the front pulley set the stud (E) on the varispeed collar (F) must be placed inside the
lower fork (G) and on the rear pulley set outside the fork for belt tightener (B), (both must
point backwards).
Tolerances in the transmission might cause that the special V-belt (A) is hitting the pins
of the pulley sets when the speed has been adjusted. In such cases the distance (X) must
be reduced.
Then follow the section ”Adjusment of speed”.
6.2 Adjustment of speed
The stop screws (J) on the speed lever should be adjusted so that the measurement (H) is
1-2 mm on the front and rear pulley, at low and high speed respectively. Tighten the coun-
ter nuts (K) when the speed is correctly adjusted.
6.3 Adjustment of bowl fixing
The bowl arms must be raised to normal working position. Loosen the counter nuts (1)
and remove the cotterpins (2). Turn the bolts (3) until correct fixing of the bowl is
achieved. By turning the bolts out of the extension tube the fixing is increased. Start by
turning one of the bolts half a revolution.
ILJ
$GMXVWLQJGLDPHWHU