User`s guide

VT104 DiamondVue User Guide 150-023

Panel Mounting Procedure

1. Cut and drill the panel (refer to panel mount drawing). Measurements are in inches.

Panel Mounting Cutout

2. If access to the side of the monitor is not available following installation, attach the power and video

cables to the side of the monitor at this time.

3. Install the monitor in the prepared cutout.

4. Install the lock nuts and washers, supplied with the monitor, behind the holes running along the sides

and top/bottom of the cutout in the panel. Extra lock nuts and washers are provided.

MOUNTING INSTRUCTIONS

7.1

Panel Mount Procedure

Section

Mechanical Drawings

Model Description Page(s)

VT104P 10.4” DiamondVue Panel Mount Mechanical Drawing 16

VT104R 10.4” DiamondVue Rack Mount Mechanical Drawing

VT104W 10.4” DiamondVue Wall Mount Mechanical Drawing 17

VT104R24 10.4” 24 Inch Wide Rack Mount Mechanical Drawing 18

Rack Mounting Procedure

1. Carefully remove the monitor from its packaging.

2. Locate holes in the cabinet front mounting rails corresponding to the holes in the monitor front panel.

Install clip nuts behind the holes in the rails if threaded rails are not provided.

Rack Mount Procedure

7.2

Note:

Use #10-32 nuts for mounting.

Note:

The mounting rails that run vertically along the inside edges of the front opening of an EIA rack cabinet

can be of two types: “Wide” rails have holes spaced 0.5"(12.7 mm) and 1.25"(31.8 mm) on centers, in a

repeating pattern. Wide rails are prevalent in Europe. “Universal” rails have holes spaced 0.5"(12.7

mm), 0.625"(31.8 mm), and 0.625"(31.8 mm) on centers, in a repeating pattern. Thus, the universal

rails have a hole pattern that contains the wide pattern but provides an additional hole at the midpoint

of the pattern. Universal rails are most prevalent in the US.

3. Install the monitor into the cabinet from the front.

4. Secure the monitor chassis to the cabinet by installing panel mounting screws through the holes in

the monitor front panel and into the rails behind.

5. Tighten all mounting nuts evenly to a torque of 24 inch-pounds.

ATTENTION: Mounting nuts must be tightened to a torque of 24 inch-pounds

to provide panel seal and avoid potential damage. Vartech Systems

assumes no responsibility for water or chemical damage to the monitor or

other equipment within the enclosure due to improper installation.

6. Attach the power and video cables to the side of the monitor if

you have not already done so.