User`s guide

VT104HBU User Guide 21 150-101

MOUNTING INSTRUCTIONS

7.1

Panel Mount Procedure

Panel Mounting Procedure

1. Cut and drill the panel (refer to panel mount drawing). Measurements are in inches.

Panel Mounting Cutout

2. If access to the side of the monitor is not available following installation, attach the power

and video cables to the side of the monitor at this time.

3. Install the monitor in the prepared cutout.

4. Install the lock nuts and washers, supplied with the monitor, behind the holes running along

the sides and top/bottom of the cutout in the panel. Extra lock nuts and washers are

provided.

Note: Use #10-32 nuts for mounting.

5. Tighten all mounting nuts evenly to a torque of 24 inch-pounds.

ATTENTION: Mounting nuts must be tightened to a torque of 24 inch-pounds to provide panel

seal and avoid potential damage. Vartech Systems assumes no responsibility for water or

chemical damage to the monitor or other equipment within the enclosure due to improper

installation.

6. Attach the power and video cables to the side of the monitor if you have not already done

so.

Section