User`s guide

VT190 ColorVue User Guide 150-077

2.5

Signal Connections Cont.

You can use an HD-15 connector cable or a BNC adapter cable to connect the flat

panel monitor to the host computer. The HD-15 video cable (supplied in the kit) you

use with this monitor is equipped with a conventional HD-15 connector at each end.

HD-15 Video Connector

The following table provides the pin numbers and

corresponding pin assignments for the HD-15 video

connector.

Note: The following figure is the view looking into the pin end of the male connector or

solder term end of the female connector.

Pin Signal (DVI-I) Pin Signal (DVI-I) Pin Signal (DVI-I)

1 T.M.D.S. Data2- 9 T.M.D.S. Data1- 17 T.M.D.S. Data0-

2 T.M.D.S. Data2+ 10 T.M.D.S. Data1+ 18 T.M.D.S. Data0+

3 SGND 11 SGND 19 SGND

4 Not used 12 Not used 20 Not used

5 Not used 13 Not used 21 Not used

6 DDC Clock 14 DDC Power 22 SGND

7 DDC Data 15 Ground 23 T.M.D.S. Clock+

8 Not used 16 Hot Plug Detect 24 T.M.D.S. Clock-

Pin Signal (DVI-I)

C1 Not Used

C2 Not Used

C3 Not Used

C4 Not Used

C5 Not Used

DVI-I Connector (Digital / Analog)

Pin Signal (HD15) Pin Signal (HD15) Pin Signal (HD15)

1 Red Video 6 Red Video Ground 11 Monitor Ground

2 Green Video 7 Green Video Ground 12 DDC data

3 Blue Video 8 Blue Video Ground 13 Horizontal Sync

4 Not Used 9 +5 V 14 Vertical Sync

5 Ground 10 PC detection 15 DDC clock

C4 C3