User`s guide

10.4” C1-D2 Compliant Panel Mount PC 486-0029-00-00

BEFORE MAKING ANY CONNECTIONS OR APPLYING POWER,

FIRST READ THROUGH THE ENTIRE MANUAL

Panel Mount Procedure

Panel Mounting Procedure:

1- Cut and drill the panel (refer to the panel mount drawing, Figure A). Measurements are

provided in inches and millimeters.

Panel Mounting Cutout:

1- If access to the bottom of the enclosure is not available following installation, attach the

power and all necessary cables to the bottom side of the enclosure at this time.

2- Install the enclosure in the prepared cutout.

3- Secure the enclosure using the lock nuts and washers, supplied with the unit, behind the

holes running along the sides and the top and bottom of the cutout in the panel. Extra lock

nuts and washers are provided.

4- Tighten all mounting hardware to a torque of 24 inch-pounds.

ATTENTION: Mounting nuts must be tightened to a torque of 24 inch-pounds to provide a

proper panel seal and avoid potential damage. Vartech Systems assumes no responsibility for

water or chemical damage to the monitor or other equipment within the enclosure due to

improper installation.

NOTE: An easily accessible 15A fused or breaker protected outlet must be provided for

installation of the unit.

5- Attach the power, video and system cables to the bottom side of the enclosure if you have

not already done so.