User`s guide

12
VT170DiamondVue/CrystalVueUser’sGuide150‐179


MAINTENANCE


SECTION 6
6.1 Cleaning
Occasionally clean the display panel and cabinet with a soft cloth dampened (not soaked) with a mild (non-abrasive)
glass cleaner. Keep turning a fresh side of the cloth toward the screen surface to avoid scratching it with accumulated
grit.
Note: The solvent should be applied only to the cloth, and not directly on the monitor screen.
Do not use paper products as they may scratch the surface. To minimize the risk of abrasion, allow the screen to stand
dry. Special care should be taken when cleaning a touch screen or polycarbonate shield that is installed over the screen.
Abrasive and certain chemical cleaners can easily damage the surface. Never use alcoholic or ammoniac cleaners to
clean the polycarbonate shield or a touch screen.
Note: For best results cleaning a monitor with the optional antireflective tempered glass display shield, a solution of
denatured alcohol is recommended to thoroughly clean the display.
Replacing a Line Cord
To avoid shock and fire hazards, the monitor’s power cord should be replaced if the insulation becomes broken or if it
develops a loose internal connection.
Other Maintenance
Qualified service personnel should perform all maintenance, except for the power cord replacement described above.