User`s guide

19.0 Panel Mount PC 486-0010-01-02

Super IO Device

Scroll to this item and press <Enter> to view the sub menu Super IO Device.

 Onboard FDC Controller

Select Enabled, if your system has a floppy disk controller (FDC) installed on the system

board and you want to use it. If you install and-in FDC or the system has no floppy drive,

select Disabled in this field. Options: Enabled and Disabled.

 Onboard Serial Port 1/2

Select an address and corresponding interrupt for the serial port.

 Onboard Serial Port 3

This item assigns which I/O address to access onboard serial port 3.

 Serial Port 3 Use IRQ

This item selects a corresponding interrupt for the third serial port.

 Onboard Serial Port 4

This item assigns which I/O address to access onboard serial port 4.

 Serial Port 4 Use IRQ

This item selects a corresponding interrupt for the fourth serial port.

 Onboard Paralellel Port

This item allows you to determine the I/O address for onboard parallel port. Options are:

“378H/IRQ7”, “278H/IRQ5”, “3BC/IRQ7” and “Disabled”.

 Parallel Port Mode

Select an operating mode for the onboard parallel (printer) port. Select Normal unless your

hardware and software require another mode in this field. Options are: “EPP1.9”, “ECP”,

“SPP”, “ECPEPP1.7” and “EPP1.7”.

 EPP Mode Select

Select EPP port type 1.7 or 1.9.

 ECP Mode Use DMA

Select a DMA channel for the parallel port while using the ECP mode.

Press <Esc> to return to the Integrated Peripherals page, and press it again to the Main Menu.