User`s guide

11

Main Source : Select the input video signal

VGA 1 / Composite Video / S-Video / VGA 2 / DVI / HD/SD Component

Utilities :

Setup 4
Auto Picture Setup
#
4 : Auto adjust the image position, phase and size
Auto Color Gain
#
4 : Auto Color Calibration (Function in ARGB mode ONLY – See
appendix IV)
Manual Clock
#
: Adjust the image horizontal size
Manual Phase
#
: Fine tune the data sampling position (adjust image
quality)
Auto Source Seek : OFF / ON
ON – Auto source select always enable
OFF – Disable auto source select function
Auto Power : OFF / ON
ON – Enable soft power off function if absence of input signals
OFF – Disable soft power function
Video Standard (SD)** : Auto / NTSC / PAL / SECAM / NTSC 443
Gamma : 1.0 / 1.6 / 2.2
OSD 4

H Position : Move the OSD menu image horizontally
V Position : Move the OSD menu image vertically
Timeout (sec) : 1 – 20 : Adjust the OSD menu timeout period in a step of 1
seconds (max 20 seconds)
Language : English / Simplified Chinese : Select OSD menu language display
Transparency : 0 – 100 steps


Color Temperature 4
Color Temp : 9300K / 8000K / 6500K / 5000K
Red : 
Green : 
Blue : 


Hot Key 4
Hot key 1 : Brightness / Contrast / Input / Aspect / Volume
Hot key 2 : Brightness / Contrast / Input / Aspect / Volume

Reset to Factory Defaults 4
Factory Defaults
Reset Color Gain
#

DDC Updates
** : FUNCTION IN VIDEO MODE ONLY
# : DISPLAY AND FUNCTION IN VGA MODE ONLY