User manual

Push the lock of the battery holder towards the centre of the housing and pull out the battery

holder like a drawer. Insert the batteries. Check for correct polarity as shown on the back of the

remote control. Slide the battery holder back into the remote until it clicks into place.

When shipping, the batteries are already installed in the remote and protected against dis‐

charge by a transparent plastic lm. Remove the plastic lm before initial use.

NOTICE!

Possible damage by leaking batteries

Leaking batteries can cause permanent damage to the device.

Take batteries out of the device if it is not going to be used for a longer period.

Inserting batteries into the

remote

Installation

BAT.PAR 6 RGBWA BAT.PAR 6 RGBUV

LED spotlight