User manual
Table Of Contents
7 Operating
7.1 Starting the device
Turn on the power using the main switch. The display shows the current operation mode.
7.2 Operating on the unit
Wait about 15 seconds until the display turns dark after conrming the last change of the set‐
tings. Then the settings are saved.
Press [MENU], [UP] or [DOWN] repeatedly until the display shows ‘Addr’ . Conrm with [ENTER].
Now you can set the number of the rst DMX channel to be used by the device (DMX address).
Use [UP] and [DOWN] to select a value between 1 and 512 (display shows ‘A001’ … ‘A512’ ).
Conrm with [ENTER].
Make sure that this number matches the conguration of your DMX controller.
DMX address
Operating
32
BAT.PAR 6 RGBWA BAT.PAR 6 RGBUV
LED spotlight