User manual

Press [MENU]. Then use [UP] or [DOWN] to select the menu item ‘dMH’ . Press [ENTER]. Select
either the 1-channel DMX mode (display ‘01Ch’ ), the 4-channel DMX mode (display ‘04Ch’ ) or
change to the input of the DMX address (display ‘dxxx’ ). Conrm with [ENTER].
If you have selected the menu item ‘dxxx’ , set the number of the rst DMX channel used by
the device (DMX address). Use [UP] and [DOWN] to select a value between 1 and 512 (display
shows ‘A001’ … ‘A512’ ).
When the display shows the desired value, press [ENTER] to conrm the selection and then
[MENU] to return to the parent menu.
Make sure that this number matches the conguration of your DMX controller.
Press [MENU]. Then use [UP] or [DOWN] to select the menu item ‘AUT’ . Press [ENTER]. Use [UP]
or [DOWN] to choose between ‘AutM’ (automatic show), ‘AutP’ (automatic program) or ‘AutF’
(strobe program). When the display shows the desired value, press [ENTER].
To set the speed, select a value between ‘S01’ (slow) and ‘S99’ .
When the display shows the desired value, press [ENTER] to conrm the selection and then
[MENU] to return to the parent menu.
DMX address
Operating mode ‘Automatic’
Operating
LED Derby ST
31
LED eect