Ford F-150 SVT Raptor ® ® ® owner’s manual ® bedienungsanleitung manuel de l’utilisateur m a n u a l e d e l l’ u t e n t e
EN
Notice WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury. All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product.
Water-resistant Vehicle with Waterproof Electronics / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / Your new Horizon Hobby vehicle has been designed and built with a combination of waterproof and waterresistant components to allow you to operate the product in many “wet conditions”, including puddles, creeks, wet grass, snow and even rain.
Table of Contents / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / Quick Start / / / / / / / / / / / / / / / / / / / / / introduction 6 Introduction Thank you for purchasing this Vaterra® product! The Ford F-150 SVT Raptor is a special concept edition that is a reflection of our dedication to embodying the essence of monster truck excitement.
Components / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / »» 1/10-Scale Ford® F-150® SVT® Raptor® RTR Truck »» Spektrum™ DX2E 2.
Spektrum DX2E Radio System / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / For more information on the transmitter, go to www.horizonhobby.com and click on the support tab for the Spektrum DX2E to download the instruction manual. AVC Sensitivity The ST RATE dial adjusts the sensitivity, or stability, value in the receiver.
/////////////////////////////////////////////////////////////////////////////////////////////////////////// Installing The Transmitter Batteries 1 CAUTION: NEVER remove the transmitter batteries while the vehicle is powered ON, as loss of control, property damage or injury may result. Push in the battery cover a small amount to release the retaining tab, then remove the cover. 2 Install 4 AA batteries, taking care to align the battery polarity to the diagram in the transmitter’s battery case.
run time / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / The largest factor in run time is the capacity of the battery pack. A larger mAh rating increases the amount of run time experienced. The condition of a battery pack is also an important factor in both run time and speed. The battery connectors may become hot during driving.
Dynamite 70A Waterproof Sensorless Brushless ESC / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / ESC LED Status »» No ESC LEDs will glow when there is no throttle input from the transmitter. »» The red ESC LED glows when there is any throttle input from the transmitter. Audible Warning Tones 1 Input voltage: The ESC checks the input voltage when it is powered ON.
///////////////////////////////////////////////////////////////////////////////////////////////////// Default Settings Programmable Items Programmable Value 1 2 3 4 5 6 7 8 1 Running Mode Forward Only with Brake Forward/Reverse with Brake 2 Drag Brake Force 0% 3 Low Voltage Cutoff Threshold nonprotection 5% 10% 15% 20% 25% 30% 40% 2.6V/Cell 2.8V/ Cell 3.0V/ Cell 3.2V/ Cell 3.
Dynamite Fuze 540 4-pole 3300Kv Sensorless Brushless Motor gear chart / / / / / / / / / / / / / / / / / / / / / / / / / / Gearing Final Drive Ratios Installing a pinion gear with less teeth or a spur gear with more teeth will provide greater torque but will reduce top speed. Likewise, a pinion gear with more teeth or a spur gear with fewer teeth will reduce torque and increase top speed.
Changing the Travel Adjust Settings / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / The minimum Travel is 75%, and the Maximum travel is 150%. IMPORTANT: If the travel is changed on the DX2E, you must rebind and calibrate the SRS4200. 1 Hold the trigger in the full brake position while powering on the transmitter. The LED flashes rapidly, indicating the programming mode is active.
Troubleshooting Guide / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / Problem Possible Cause Solution Vehicle does not operate »» Battery not charged or connected »» ESC switch not ON »» Transmitter not ON or low battery »» Pinion not meshing with spur gear »» Pinion spinning on motor shaft »» Slipper too loose »» Transmission gears stripped »» Drive pin broken »» Servo plug not in receiver proper
Limited Warranty / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / What this Warranty Covers Limitation of Liability WARRANTY SERVICES Horizon Hobby, Inc., (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase.
/////////////////////////////////////////////////////////////////////////////////////////////////////////// NOTICE: Do not ship Li-Po batteries to Horizon. If you have any issue with a LiPo battery, please contact the appropriate Horizon Product Support office. Warranty Requirements warranty and service Contact Information Country of Purchase Horizon Hobby Contact Information Address United States of America Horizon Service Center (Repairs and Repair Requests) servicecenter.horizonhobby.
fcc Information / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
