Operation Manual

17In brief
Picture no: 16993t.tif
Windscreen wiper:
Move stalk upward
§ = Off
$ = Adjustable timed
interval wipe
% = Slow
& = Fast
Stalk always moves back to starting
position. Shift to next higher or lower level:
move stalk slightly.
Push stalk past resistance point and hold:
the windscreen wiper stages are run
through; an acoustic signal sounds at
position §.
Press stalk down from position §:
single swipe.
6 Further information –
see pages 297, 304.
Picture no: 16994t.tif
Windscreen wiper:
Adjustable timed interval wiper
To set the wiper interval to a value between
2 and 15 seconds:
Switch on ignition.
Press stalk down from position §.
Wait the desired interval.
Set the stalk to timed interval wipe $.
The interval remains stored until the next
change or the ignition is switched off.
Switching the ignition on and moving the
stalk to $ sets the interval to 4 seconds.
Picture no: 16995t.tif
Automatic wiping with rain
sensor 3:
Move stalk upward
$ = Automatic wiping with
rain sensor
Automatic wiping $: the rain sensor
detects the amount of water on the
windscreen and automatically regulates
the windscreen wiper.
To switch off, move stalk downwards.
6 Further information –
see pages 297, 304.