Operation Manual

127Instruments, controls
Automatic wiping with rain sensor 3:
To activate, press stalk briefly up
The rain sensor detects the amount of
water on the windscreen and automatically
controls the windscreen wipers. Adjust the
sensitivity of the system using the adjuster
wheel:
Keep sensor area of rain sensor clean by
operating the windscreen wash system.
Windscreen wash system and headlight
wash system 3
To activate, pull stalk on steering wheel
The wiper is switched on for several wipe
operations. A single after-wipe occurs at
speeds of up to 80 mph (130 km/h).
The headlight wash system 3 is ready for
operation when the headlights are
switched on. Wash fluid is sprayed onto the
headlights once. Then the headlight wash
system is disabled for 2 minutes.
On vehicles fitted with rain sensor 3, keep
the sensor area clean.
Rear window wash and wiper system
Push stalk forward to switch on.
The rear window wiper swipes in timed
interval mode.
The tailgate wiper switches on
automatically when the windscreen wipers
are switched on and reverse gear is
engaged.
Push stalk forward again to switch off.
The rear window wash system will remain
on for as long as the stalk is held in the
forward position.
The rear window wash system is
deactivated when the fluid level is low.
$ = Automatic wiping with rain sensor
§ =Off
Adjuster wheel right = High sensitivity
Adjuster wheel left = Low sensitivity