Owner`s manual

88 Lighting
Hazard warning lamps
Operated with the ¨ button.
To aid location of the pushbutton, the red
surface is illuminated when the ignition
switched on. When the button is pressed,
its control indicator flashes in time with the
hazard warning lamps.
Headlamp range adjustment ?
Adjust headlamp range to the vehicle load
with dipped beam switched on:
Turn adjuster wheel to required position.
Adjustment positions
Position 3 is not used.
Door-to-door lighting 3
Dipped beam illuminates for approx.
30 seconds after switching on and closing
the driver’s door.
To activate
1. Switch off ignition.
2. Remove ignition key.
3. Open driver’s door.
4. Pull turn signal stalk toward steering
wheel.
5. Close driver’s door.
If the driver’s door is left open, lighting will
go out after two minutes.
The lighting goes out immediately if the
ignition key is inserted or the turn signal
stalk on the steering wheel is pulled again.
0 = Driver’s seat occupied
1 = Seats occupied
2 = Seats occupied and full load
in luggage compartment