Owner`s manual

148 Lighting
Door-to-door light function3
Dipped beam and reverse lights 3
illuminate for around 30 seconds after the
driver exits the vehicle and closes his door.
To activate
1. Switch off ignition.
2. Remove ignition key 3.
3. Open driver’s door.
4. Pull turn signal stalk toward steering
wheel.
5. Close driver’s door.
If the driver’s door is left open, the lights will
go out after two minutes.
The light is switched off immediately by
inserting the key into the ignition or pulling
the turn signal stalk again with the driver’s
door open.
Instrument illumination,
information display illumination
Comes on when ignition is switched on.
Brightness can be adjusted when the
exterior lights are on: Push to release
knob k and then turn it clockwise or
anti-clockwise and hold until the desired
brightness is obtained.
Display mode 3, see page 134.
Courtesy light
Automatic interior light
Comes on automatically when the vehicle is
unlocked with the remote control, when a
door is opened or when the key is removed
from the starter switch after the ignition is
switched off.
Goes off automatically after a delay when
the doors are closed or immediately when
the ignition is switched on or the doors are
locked.
Front courtesy light
To operate manually from inside when the
doors are closed:
On = Press button c
Off = Press button c again