Owner`s manual
Table Of Contents
- Introduction
- In brief
- Keys, doors and windows
- Seats, restraints
- Storage
- Instruments and controls
- Controls
- Warning lights, gauges and indicators
- Speedometer
- Odometer
- Tachometer
- Fuel gauge
- Engine oil level monitor
- Service display
- Transmission display
- Control indicators
- Turn signal
- Seat belt reminder
- Airbag and belt tensioners
- Airbag deactivation
- Charging system
- Malfunction indicator light
- Service vehicle soon
- Stop engine
- Brake system
- Antilock brake system (ABS)
- Upshift
- Electronic Stability Program
- Engine coolant temperature
- Preheating
- Diesel particle filter
- Engine oil pressure
- Low fuel
- Exterior light
- High beam
- Fog light
- Rear fog light
- Cruise control
- Information displays
- Vehicle messages
- Trip computer
- Tachograph
- Lighting
- Climate control
- Driving and operating
- Vehicle care
- General Information
- Vehicle checks
- Bulb replacement
- Electrical system
- Vehicle tools
- Wheels and tyres
- Towing
- Appearance care
- Service and maintenance
- Technical data
- Customer information
- Index
120 Vehicle care
Place a container underneath the
filter housing. Loosen the knurled
screws on the filter cover and on the
lower part of the filter by approx. one
turn, to drain off the water.
The filter is drained as soon as diesel
fuel emerges from the knurled screw
at the bottom. Retighten the two
screws.
Check diesel fuel filter at shorter
intervals if the vehicle is subjected to
extreme operating conditions.
Diesel fuel system
bleeding
If the fuel tank has been run dry, it will
be necessary to air vent or bleed the
diesel fuel system.
Fill the tank with fuel and proceed as
follows:
1. Remove the protective cover from
the in-line supply pump.
2. Place a suitable container
underneath the fuel filter vent
screw to collect fuel.
3. Loosen the vent screw (arrowed)
by one turn.
4. Manually operate the in-line
supply pump slowly and steadily
until fuel discharging from the
loosened vent screw is free of air
bubbles.
5. Retighten the vent screw.
6. Refit the protective cover to the in-
line supply pump.
Wiper blade replacement
Wiper blades on the windscreen
Lift wiper arm, press retaining clip
towards wiper arm and detach wiper
blade.
Wiper blade on the rear window
Lift wiper arm, rotate wiper blade and
detach.