Owner`s manual
Table Of Contents
- Introduction
- In brief
- Keys, doors and windows
- Seats, restraints
- Storage
- Instruments and controls
- Controls
- Warning lights, gauges and indicators
- Speedometer
- Odometer
- Tachometer
- Fuel gauge
- Engine oil level monitor
- Service display
- Transmission display
- Control indicators
- Turn signal
- Seat belt reminder
- Airbag and belt tensioners
- Airbag deactivation
- Charging system
- Malfunction indicator light
- Service vehicle soon
- Stop engine
- Brake system
- Antilock brake system (ABS)
- Upshift
- Electronic Stability Program
- Engine coolant temperature
- Preheating
- Diesel particle filter
- Engine oil pressure
- Low fuel
- Exterior light
- High beam
- Fog light
- Rear fog light
- Cruise control
- Information displays
- Vehicle messages
- Trip computer
- Tachograph
- Lighting
- Climate control
- Driving and operating
- Vehicle care
- General Information
- Vehicle checks
- Bulb replacement
- Electrical system
- Vehicle tools
- Wheels and tyres
- Towing
- Appearance care
- Service and maintenance
- Technical data
- Customer information
- Index
122 Vehicle care
Front turn signal lights
1. Remove bulb holder from reflector
housing by rotating through 90°.
2. Renew bulb.
3. Install bulb holder in reflector
housing.
Tail lights
Rear brake, turn signal and tail
lights
1. Remove 3 screws (using the tool
supplied).
2. Carefully pull lamp assembly from
retaining pins on the outer side
and remove.
3. Twist bulb holder to separate from
lamp assembly.
4. Renew bulb.
5. Push to install the bulb holder into
the lamp assembly - then twist to
secure.
6. Check that the wiring harness is
located correctly.
7. Replace lamp assembly into
original position, ensuring that it is
seated correctly.
8. Fit lamp assembly onto retaining
pins and replace 3 screws.