User's Manual

Storage Box
Measurement Error
＜0.3 °C
RF Carrier Frequency
915 MHZ 接收
Charging Voltage
DC 5.0V
Battery
2000mAh Lithium Polymer Battery
Standby Time
24 hours
Charging Time
3 hours
Charging Current
800 mA
Net Weight
Dimension
GET STARTED
1. Turning ON the Smart Thermometer
• Storage Box
Press and hold the Power Button, the LED display will light up from left to right, correctly
showing the ambient temperature and the battery level of both storage box and
temperature sticker.
• Temperature Sticker
Take the temperature sticker out of the storage box, it will be turned on automatically
with LED indicator (on the temperature sticker) flashing 3 times.
2. Pairing
• The temperature sticker will pair with the storage box automatically.
• Successfully paired: LED Display show the Body Temperature Mode (Body Temperature
Mode indicator on).
3. Body Temperature Measurement
• Paste Non-Woven Tape on Temperature Sticker
1) Take out one piece of non-woven tape, rip off the release paper 1, then paste it to
the back side of the temperature sticker. After pressing for 3s, put the temperature
sensor through the hole of the non-woven tape.
2) Rip off the release paper 2, then fix the temperature sensor on the back side of the non-
woven tape.
• Measure the Body Temperature
1) Paste the fixed temperature sensor to the armpit, and lightly press to make sure it
is closely attached to the skin.
2) Rip off the release paper 3, then paste the temperature sticker to the body. The
temperature sticker will start measuring the body temperature.
4. Ambient Temperature Detection
• Place the temperature sticker back into the storage box with the metal patch facing
down and plug in the power supply.
• At this point, the LED display starts to show the ambient temperature.
5. Switching between °C and °F
• Toggle the switch button on the bottom of the storage box to switch between °C and °F.