User Manual

Dash Cam Installation

1. Turn off the car engine.

2. Stick the car mount onto your car windshield (ideally right in the middle).

3. Fix the VAVA ① Dash Cam onto the mount via the magnet.

4. Connect the USB cable to the micro USB port of the ① Dash Cam. Run the cable along the edge of the windshield, tucking it away in the

seams, and extend it all the way to the USB port of the ② Car Charger. Be sure to keep it away from the airbag area.

5. Insert the ② Car Charger into your cigarette lighter, connect the ① Dash Cam to the Car Charger.

6. Plug the rear camera connecting cable into the ③ rear camera connecting port, and install the ③ rear camera properly.

7. Adjust the ① Dash Cam to keep the lens level with the ground.

8. Start the car engine to check if the ① Dash Cam is working properly.

Snapshot Button

Note：The Snapshot Button enters standby mode once there is no operation for 1 minute. Press again to restart and take a photo.

Dash Cam and Snapshot Button Pairing

Dash Cam and Snapshot Button Pairing: Once the Dash Cam is turned on, press and hold the Snapshot Button for 5 -20 seconds until you

hear 4 beep sounds. This means that they are synced.

Installing the Snapshot Button

① Install the Snapshot Button onto the steering wheel with the 3M sticker.

② Attach it to your key chains if needed.

Using the Snapshot Button

① Taking photos: Press once to take photos

② Taking short videos: Press and hold for 3 seconds until you hear a beep to take videos.

Replacing the battery:

Batterry Model：Lithuim Battery CR 2032 3V

Replace the battery: Open the Bluetooth Button and put the battery inside with the right polarities.

05/06

VAVA Dash Cam App Download

Please search ‘VAVA Dash’ in App Store or Google Play to download the App.

Note: Systems supported: Android 4.4 and above / iOS 8.0 and above.